How to Install Door Trim Without Nail Gun

Door trim not just gives a finishing touch to your home and office doors but also serves as protection for the main door. It keeps the dust from getting inside your rooms. They are widely available in various designs, materials, colors, and styles which can be easily matched with any exterior or interior design of a house or office. If you need new door trim, you will have to hire someone else for this work because there is no way you will choose to do this job yourself (if you are thinking of doing so, then think again).

How to Install Door Trim Without Nail Gun

If you want to replace an old door trim, you can do it yourself if you know how to install it correctly. Today I’m going to tell you how to install door trim without using a nail gun.

Step-wise Guide on How to Install Door Trim Without Nail Gun

Step 1 :

 Choose a style that’s best suited for the door trim.

Step 2:

Before you start installing the panels onto the door trims, apply some adhesive to them. Use your hammer to make sure they don’t move around or flop around while you’re sticking them into position.

Step 3 :

The next step is to apply finishing nails from the outside and into the inside to hold the trim in place in an air-tight fashion. Be careful not to hammer the nails too hard and spoil your painting job!

Step 4 :

Now, put all the nail holes with wood filler and allow it to dry thoroughly. If your surface had themes like antiques, you would have to apply some distressing technique on your door trims before applying the paint. This will give it a more dainty look. You can use your nail gun to install this material as well. Now take a small putty knife and spread some texture paste onto the trims in the random or desired manner.

Step 5 :

Allow the texture paste to dry completely for 24 hours to become hard and dry. Make sure to trim off any excess paste; otherwise, it might cause trouble while painting!

Step 6 :

After the wood filler has dried, apply two coats of fresh white primer. Allow the primer to dry completely, with minimal tackiness visible on its surface. Let the coats dry overnight before proceeding to the next step.

Step 7 :

Apply two coats of your favorite paint onto the door trims with a fine mist sprayer to avoid any lumps! If you’re using a roller, then apply just one coat. Let these coats dry up for at least 6-8 hours for complete tackiness to go away. Step 8: Now rub lotion into your hands and smooth out everything with it after it’s completely dried; this will act as a great sealant and finish off your job in an elegant manner! Your door trim is now ready!!

Precautions While Learning How to Install Door Trim Without Nail Gun

While installing door trim without a nail gun, you should be careful about the following:

  • Before beginning installing door trim without a nail gun, make sure that exterior and interior paint are dry.
Installing Door Trim
  • Even though this process minimizes damage to surfaces when compared with using a nail gun, it can still cause dents if not done carefully. Hence, it would help if you protected all the surrounding areas before installing door trim without a nail gun.
  • You must also protect water lines, pipes, and electrical outlets when doing this task as they could get damaged otherwise. Ensure that these things are protected during the fitting of exterior moldings, too, as they could get affected if you don’t install wood flooring properly on them.
  • When installing door trim without a nail gun, you must install all the interior moldings first and then move on to exterior ones. This will ensure that you don’t damage any of the surrounding areas in case of an accident while using this process to install door trim without a nail gun, even if it is quite unlikely that one would get injured from doing so.
  • Electrical outlets should also be protected with metal boxes and plastic plates, which are available at home improvement stores around your area, or you can order them online too since they are quite important when installing wood flooring properly without causing any harm to homeowners who aren’t very skilled in this field but want their project to turn out perfect as well as avoiding getting sued by people who could get injured by one’s negligence or accident.
  • You should also protect water lines and pipes if you are installing door trim without a nail gun, but in case if you have to fit wood flooring over them, then it won’t be possible to do so without causing any damage to these things as well as other areas around them.

Disadvantages of Using Nail Gun

A nail gun is very harmful. A nail gun can cause injury to your finger. It will take more time if you use the machine rather than using a hammer or nails. If you miss a screw, it is hard to remove it as compared to other tools. It’s a wastage of energy compared to the hammering of nails manually by hitting them with a hammer one by one with our hands. There are many advantages to manual work than using machines for any purpose, such as door trimming. Using nail guns is not preferable because many hazards might result from using this machine. When you use nail guns, you must wear safety goggles so that your eyes don’t get hurt when there comes out nails.

You Can Check It Out to Do Cordless Nailers Work

Directions for Using a Nail Gun

  • Insert the nail heads into the nail gun.
  • Use a strip of tape to wrap around your fingers and palm for protection from sharp edges (recommended).
Use a Strip of Tape
  • Move your hand up and down rapidly while holding the device firmly against the wood surface until all nails are in place.
  • Make sure you remove any excess framing by using a hammer or pry bar so that it’s flat with wallboard before painting or hanging pictures on it.
  • For good measure, use a pencil eraser to rub over the wallboard at each nail point so that walls look smooth after they are painted; this also gives an even finish when painting with latex paintbrushes. In addition, this will make the area look neater and professional looking by hiding any protruding nail heads.

There is a lot of work and time that goes into installing door trim without the need for an air-powered nail gun, but it’s more affordable if you do it yourself. However, if you have your own nail gun and prefer to use one, there are many videos on youtube to show you how to install trim using this tool effectively.

Frequently Asked Questions

Can You Put Up Trim Without a Nail Gun?

There are a few ways to trim without a nail gun. You can use a handsaw, hacksaw, or even a standard utility knife. Just be sure to use caution and take your time, so you don’t accidentally cut into the wood too deeply.

Which Way Does Door Trim Go?

There is no one right answer to this question as it depends on the type of door trim you are installing. However, in general, door trim goes in the same direction as the hinges on your door.

The Hinges on Your Door

Can You Use Liquid Nails to Install Baseboards?

Yes, you can use liquid nails to install baseboards. However, it is important to note that this is a temporary solution and should only be used until a more permanent solution can be found.

Liquid nails are a fast and easy way to install baseboards, but they are not the most durable option. They can easily become damaged by moisture and dust, which could lead to leaks and water damage.

Instead of using liquid nails, consider using an adhesive such as wood glue or a joint compound. These adhesives are more durable and will last longer than liquid nails without the need for additional repairs.

Can You Glue Wood Trim to Drywall?

It depends on the type of wood trim that you are trying to glue to drywall. However, if you are using a wood trim that is relatively thin, then it may be possible to glue it directly to the drywall without any additional adhesives.

Trying to Glue to Drywall

Conclusion

This is a short guide for all the homeowners and people who want to do this task by themselves. If you have any questions regarding how to install door trim without nail gun, you can always find answers by searching on the internet or asking someone who has already passed this hurdle beforehand.  I hope that these instructions will come in handy when installing the best quality door trim for your house. Thank you and have a nice day!

You may read also: How to Remove Door Stop Molding

Angela Ervin

Angela Ervin

Angela is the executive editor of DIY quickly. She began her career as an interior designer before applying her strategic and creative passion to lifestyle and home. She has close to 15 years of experience in creative writing and online content strategy for housekeeping, home decorations as well as other niche efforts. She loves her job and has the privilege of working with an extraordinary team. She lives with her husband, two sons, and daughter in Petersburg. When she's not busy working she spent time with her family.

We will be happy to hear your thoughts

Leave a reply

DIY Quickly
Logo