What Happens When a Garage Door Spring Breaks
Introduction:
The primary function of a garage door spring is to lift the garage door when it is left open. However, when the spring breaks, you will notice that either your whole door won’t shut properly and or it will not go up all the way when opened. Today I will be discussing what happens when a garage door spring breaks.
How Does a Garage Door Spring Break?
A broken garage door spring can be caused by an overload. This means that the spring is under a lot of tension and could snap at any moment. If you hear cracking sounds coming from the spring, this is a sign that it is about to break. Ignoring a broken spring is very dangerous because it could fall and hurt someone.
What Are The Signs of Garage Door Spring Damage?
If you have noticed that your garage door is not opening or closing as well as it should be, then you might have a problem with the springs. This can usually be noticed if there are problems like:
The doors were just going up and down instead of opening or closing smoothly. A lot of this has to do with how well the springs are tensioned. If they are loose enough, they will allow the door to move without much resistance, making them less powerful. If one of the springs snaps, where does it go? If your spring breaks, you would probably have an idea about what happens next. The spring breaks in half right away, so it doesn’t get stuck somewhere inside or roll out onto the floor unexpectedly.
When both the springs break inside a garage door, it will often affect how safe the door is. Proper tension in the spring is significant in keeping your family and anyone else who might use this door to be safe.
However, this can pose a problem if you have kids or pets that are not staying away from the garage door. If a spring breaks and it isn’t noticed right away, they could easily trip over it without knowing. So be sure to find all of your broken parts and fix them before using any part of your garage.
What Happens When a Garage Door Spring Breaks? Detailed Discussion:
If a garage door spring breaks, the door will fall down and might hit something like a wall or car. This could cause severe injury or damage to other property.
Your garage door has springs on both ends of the tracks. These springs are made from coils of steel and come in different sizes and strengths. The springs help to open and close your garage door.
If a spring on your garage door breaks, it can cause the door to fly up off the tracks and could hurt someone.
The garage door will keep falling until it hits something. If there’s nothing in the way, it could fall all the way to the ground and damage any cars that are in the garage. That’s why it’s important to have two springs supporting the door, so it doesn’t fall and get damaged.
A garage door spring is a long, skinny piece of metal that helps open and close the garage door. If it breaks, the door must be lifted back into place and the old spring must be removed. The new spring is then put in its place.
It is also possible for trained professionals – who typically charge about $145 per hour – to replace garage door springs. That service can be provided by a home center, an HVAC business, or even a locksmith (as long as he has proper overhead door experience). A qualified repair person will usually be able to fix garage door springs in less than three hours.
Step-wise Guide on How to Fix Garage Door Springs:
Step 1:
The first thing to do would be to determine if there is a broken spring or not
Step 2:
If the springs are broken, this could pose a significant problem and cause damage to your vehicle and yourself too
Step 3:
The next steps would be checking for metal hardware which is required in helping you replace the springs
Step 4:
The spring cables will need replacing since they will break easily due to constant use of the garage door
Step 5:
Check for any signs of rust on gears, chains as well as in shafts. This means that it’s time for repair and replacement; A little lubricant might help restore normal function to these parts
Step 6:
Lubricate moving parts and check all pulleys and joints to make sure that they are in good condition, primarily if you have heard a lot of creaking noises
Step 7 :
It’s time to check the hinges and the tracks of the door too. Make sure that it is not loose nor worn out
Step 8:
Look closely at your door panel before replacing or repairing anything on it; Check for dents or scratches. If there are any, use sandpaper or remove them with chemicals as suggested by professionals. Now, you can attach new hardware parts in place of damaged ones; But do so only after properly cleaning off old paint that might be present on all components of your garage doors
Step 9:
The last thing to do would be lubricating every moving part once again before finally trying out your garage door
Step 10:
It’s time to check your garage door to see if it’s in good condition. If it’s not creaking or getting stuck, you’ve successfully repaired or replaced the parts causing issues.
Step 11:
It’s always a good idea to check for minor problems like this before they turn into major ones. Lubrication will help your springs last longer as well as making sure that gears operate smoothly too.
Step 12:
A final tip: Check the electric motor of your rolling system now and then because it can be worn out due to constant use, thus cause a lot of problems for you.
Precautions While Fixing a Garage Door Spring:
- Before working on any part of the spring, ensure that the garage door is entirely closed or disconnected from the power source to prevent an injury due to accidental opening.
- Be sure that no other people in your proximity avoid getting injured by accidentally falling parts of a garage door while working on it.
- Tie up long hair and wear goggles covering your eyes and protective clothing covering your arms, legs, and hands while working with springs. These safety gears will help you avoid injuries during accidents, such as the tangling of wires/ropes and pieces loosening out, which can fly at incredible speeds when under tension (even if relatively small).
- Always use proper tools like screwdrivers, wrenches, pliers, and other specific devices instead of a metal stick or rigid material, which may cause damage to the springs.
- Wear protective clothing covering your entire body to avoid being hit by falling loosened parts of a garage door while you are installing new springs. Such damage can be very severe, even leading to death cases.
Conclusion:
I hope this article has provided you all the information about what happens when a garage door spring breaks. Thank you, and have a good day!
Angela Ervin
Angela is the executive editor of DIY quickly. She began her career as an interior designer before applying her strategic and creative passion to lifestyle and home. She has close to 15 years of experience in creative writing and online content strategy for housekeeping, home decorations as well as other niche efforts. She loves her job and has the privilege of working with an extraordinary team. She lives with her husband, two sons, and daughter in Petersburg. When she's not busy working she spent time with her family.
